How to deal with the burr of titanium workpieces?
The method of this kind of mechanical treatment is, to bury the titanium material in a lot of abrasives, add some grinding and polishing compounds dissolved in water, use the principle of vibration to mix the abrasives and materials, and continuously wash the workpiece, the surface, and edges of the workpiece Angles, etc. are ground by abrasives and then polished. This technique can be used for deburring, chamfering, derusting, descaling, flattening and fine polishing for metal parts of various sizes and shapes.
Abrasives can be alumina (including fused, sintered, or natural), corundum, plastic, quartz, ceramics, etc., which can be single or mixed. The shape of these abrasives can be made into diagonal, cylindrical, diamond-shaped, etc. The reason why pre-shaped abrasives are made first is that it is more economical and wears faster than random-shaped and natural-shaped materials. According to the shape and size of the workpiece, choose abrasives of different shapes and sizes. Pumice, quartz, granite horns, shells, iron filings, and ceramic shards are some abrasives used in tumblers. The size of the abrasive grain should be larger or smaller than each hole of the part. The amount of content in the drum is also an important factor affecting the quality of the surface of the parts. The amount of people in the drum is usually 70% of the volume of the drum. The solution in the drum should be added to account for about 95% of the volume of the drum (note: when adding the acidic solution to the drum, add enough water first, and then add acid to avoid corrosion of parts during the rolling process, because the time will increase, the concentration of the built-in solution gradually decreases, and even loses its effect.)
The processing time can range from a few minutes to a few hours. The key is to choose the abrasive, which should be determined through experiments. Only in this way can a uniform and shiny appearance be obtained. After processing, the workpiece is unloaded together with the abrasive and taken out after being screened by the separator, and the recovered abrasive can be continuously returned to the machining process. Oscillating finishing machines are divided into two categories: stand-alone and online, which are selected according to production needs.
The above is about the content of "Titanium rod manufacturers analyze how to deal with the burrs of titanium workpieces". If you want to know more about titanium rods, please call us for a consultation!
